×
- Hello
- Login or Register
- Quick Links
- Live Chat
- Track Order
- Parts Availability
- RMA
- Help Center
- Contact Us
- Shop for
- Volvo Parts
My Garage
My Account
Cart
Genuine Volvo 244 Universal Joints
U - Joints- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Universal Joints found
Volvo 244 Universal Joints Part Number: 1220998
$64.89 MSRP: $76.62You Save: $11.73 (16%)Ships in 1-2 Business DaysVolvo 244 Universal Joints Part Number: 672037
$61.48 MSRP: $72.59You Save: $11.11 (16%)Ships in 1-2 Business Days
Volvo 244 Universal Joints
OEM parts are the only choice for top quality and real functionality. They pass strict checks, and they match Volvo's factory specs, so installation is easy. If you need new Universal Joints and you want quality and fit. You will find both here. Our site has a wide range of OEM Volvo 244 parts. The prices are unbeatable, allowing you to get value for money. Each genuine 244 Universal Joints comes with the manufacturer's warranty. That gives you peace of mind. We ship fast to your door. Order today, and enjoy a smooth, no-hassle upgrade with parts that fit right.
Volvo 244 Universal Joints Parts and Q&A
- Q: How to remove the circlips that retain the bearings for the spiders on Universal Joints on Volvo 244?A:Remove the circlips that retain the bearings for the spiders. Support one yoke of the joint in a vice, taking care not to distort the hollow shaft. Drive the spider as far as it will go in one direction to make the bearing cap stick out of the yoke. Repeat the process in the opposite direction, allowing the spider to be taken out of the yoke. Finally, drift the bearing cups out of the yoke.
- Q: How should you properly clean and reassemble needle bearings and universal joints on Volvo 244?A:Wash out the needle bearings thoroughly, finishing off with white spirit to remove all traces of cleaning fluid and grease, and check for signs of wear, rust or blueing and make sure the rubber seals are undamaged. Check spiders for signs of wear and replace the spiders and the bearings if any imperfections are discovered. If the yokes are damaged or the bearing cups fit loosely, replace the concerned shaft as also the yokes cannot be removed from it. To reassemble universal joints, fill bearings half full of grease and make sure that the needle rollers are neatly located around the inside of the cup. Push the spider to the side of the yoke where a bearing is being fitted to make sure that the bearing cup is pushed on the shaft properly and pushes the spider as far through the yoke as possible before sliding the bearing over it. Drive the bearing home gently with a drift slightly smaller than the bearing cup diameter and insert the circlip, doing the same for the opposite end taking care not to trap the needle rollers.
