Genuine Volvo V40 Center Console

Volvo V40 Center Console Parts and Q&A

• Rear Console, Off Black
  30620936
  Q: How to remove the Center Console on Volvo V40?

  A:

  To remove the console from models up to May 2000, start by disconnecting the battery negative lead. Next, remove the ashtray from the rear of the console and lift out the drinks holder insert to access the retaining screws at the rear section of the console, which should then be removed from the car. Undo the retaining screws for the left and right-hand side panels, carefully unclip, and remove them from the front of the centre console. For manual transmission models, unclip the gearchange lever gaiter and fold it back, while for automatic models, carefully prise out the selector lever position indicator panel, freeing the bulbholders and removing the panel. Ease the window switch panel assembly out and disconnect its wiring connectors, then remove the audio unit. If necessary, unclip and remove the storage compartment from the centre of the facia, followed by the ashtray/cigarette lighter assembly, disconnecting the wiring as it becomes accessible. Remove the screws securing the rear of the centre console front section to the floor, fully apply the handbrake, and lift the rear of the console front section over the handbrake lever, disconnecting the switch wiring connectors as they become accessible. For models from May 2000 onwards, remove the rubber tray in front of the gear lever, unclip the gaiter from the gear lever trim panel, and release the lugs around the edges of the trim panel to disconnect the wiring plug. Inside the oddments tray at the rear of the console, prise up the screw cover and remove the two screws underneath, followed by the two console retaining screws behind the gear lever. Again, fully apply the handbrake, lift the rear of the console front section over the handbrake lever, and disconnect the switch wiring connectors. To remove the front section of the console, remove the audio unit, then the two screws at the base of the radio aperture, allowing the console to be twisted out of its location. For refitting, ensure all fasteners are securely tightened, reconnect the battery, and check the operation of all switches. If console side panels need to be removed, take out the single retaining screw at the base of the facia, move the panel down towards the footwell, and cut the cable-tie securing it to the heater unit, obtaining a new one for reassembly.