How should the engine be turned and what steps are involved in removing and refitting the cylinder head for 1.8 and 2.0 litre petrol engines on 2007 Volvo V50?

Turn engine clockwise from the right. Remove battery/box, drain coolant, remove ancillaries, fuel rail, disconnect hoses/wiring. Progressively remove ten head bolts and remove head, discard gasket, clean/inspect faces, fit new gasket, lower head with No.1 ~20mm BTDC, fit new bolts, torque/angle to spec, reassemble, refill fluids, check for leaks.

Genuine 2007 Volvo V50 Cylinder Head

Head

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Cylinder Heads found

View related parts
2007 Volvo V50 Cylinder Head Part Number: 36050502
$2195.75 MSRP: $2648.13
You Save: $452.38 (18%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Cylinder Head
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 36050502
- Warranty: This genuine part is guaranteed by Volvo's factory warranty.
Fits the following 2007 Volvo V50 Submodels:
- 2.4i, i | 5 Cyl 2.4 L GAS
View related parts
2007 Volvo V50 Cylinder Head Part Number: 8252302
$3546.15 MSRP: $4282.98
You Save: $736.83 (18%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Cylinder Head
- Replaces: 36002522
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8252302
- Warranty: This genuine part is guaranteed by Volvo's factory warranty.
Fits the following 2007 Volvo V50 Submodels:
- T5, T5 R-Design | 5 Cyl 2.5 L GAS

2007 Volvo V50 Cylinder Head Parts and Q&A

Q: How should the engine be turned and what steps are involved in removing and refitting the cylinder head for 1.8 and 2.0 litre petrol engines on 2007 Volvo V50?
A: Turn engine clockwise from the right. Remove battery/box, drain coolant, remove ancillaries, fuel rail, disconnect hoses/wiring. Progressively remove ten head bolts and remove head, discard gasket, clean/inspect faces, fit new gasket, lower head with No.1 ~20mm BTDC, fit new bolts, torque/angle to spec, reassemble, refill fluids, check for leaks.